Geothermal Energy

Geothermal Energy

Geothermal energy is the heat from the Earth. It's clean and sustainable. Resources of geothermal energy range from the shallow ground to hot water and hot rock found a few miles beneath the Earth's surface, and down even deeper to the extremely high temperatures of molten rock called magma.

Almost everywhere, the shallow ground or upper 10 feet of the Earth's surface maintains a nearly constant temperature between 50° and 60°F (10° and 16°C). Geothermal heat pumps can tap into this resource to heat and cool buildings. A geothermal heat pump system consists of a heat pump, an air delivery system (ductwork), and a heat exchanger-a system of pipes buried in the shallow ground near the building. In the winter, the heat pump removes heat from the heat exchanger and pumps it into the indoor air delivery system. In the summer, the process is reversed, and the heat pump moves heat from the indoor air into the heat exchanger. The heat removed from the indoor air during the summer can also be used to provide a free source of hot water.

In the United States, most geothermal reservoirs of hot water are located in the western states, Alaska, and Hawaii. Wells can be drilled into underground reservoirs for the generation of electricity. Some geothermal power plants use the steam from a reservoir to power a turbine/generator, while others use the hot water to boil a working fluid that vaporizes and then turns a turbine. Hot water near the surface of Earth can be used directly for heat. Direct-use applications include heating buildings, growing plants in greenhouses, drying crops, heating water at fish farms, and several industrial processes such as pasteurizing milk.

Hot dry rock resources occur at depths of 3 to 5 miles everywhere beneath the Earth's surface and at lesser depths in certain areas. Access to these resources involves injecting cold water down one well, circulating it through hot fractured rock, and drawing off the heated water from another well. Currently, there are no commercial applications of this technology. Existing technology also does not yet allow recovery of heat directly from magma, the very deep and most powerful resource of geothermal energy.

Many technologies have been developed to take advantage of geothermal energy - the heat from the earth. NREL performs research to develop and advance technologies for the following geothermal applications:

Geothermal energy has been used for thousands of years in some countries for cooking and heating. It is simply power derived from the Earth’s internal heat.

This thermal energy is contained in the rock and fluids beneath Earth’s crust. It can be found from shallow ground to several miles below the surface, and even farther down to the extremely hot molten rock called magma.

HOW IS IT USED?

These underground reservoirs of steam and hot water can be tapped to generate electricity or to heat and cool buildings directly.The Geothermal pump sysytem can take advantage of the constant temperature of the upper ten feet (three meters) of the Earth’s surface to heat a home in the winter, while extracting heat from the building and transferring it back to the relatively cooler ground in the summer.

Geothermal water from deeper in the Earth can be used directly for heating homes and offices, or for growing plants in greenhouses. Some U.S. cities pipe geothermal hot water under roads and sidewalks to melt snow.

Production of Geothermal Energy

To produce geothermal-generated electricity, wells, sometimes a mile (1.6 kilometers) deep or more, are drilled into underground reservoirs to tap steam and very hot water that drive turbines linked to electricity generators. The first geothermally generated electricity was produced in Larderello, Italy, in 1904.

There are three types of geothermal power plants: dry steam, flash, and binary. Dry steam, the oldest geothermal technology, takes steam out of fractures in the ground and uses it to directly drive a turbine. Flash plants pull deep, high-pressure hot water into cooler, low-pressure water. The steam that results from this process is used to drive the turbine. In binary plants, the hot water is passed by a secondary fluid with a much lower boiling point than water. This causes the secondary fluid to turn to vapor, which then drives a turbine. Most geothermal power plants in the future will be binary plants.

Geothermal energy is generated in over 20 countries. The United States is the world’s largest producer, and the largest geothermal development in the world is The Geysers north of San Francisco in California. In Iceland, many of the buildings and even swimming pools are heated with geothermal hot water. Iceland has at least 25 active volcanoes and many hot springs and geysers.

Advantages and Disadvantages

There are many advantages of geothermal energy. It can be extracted without burning a fossil fuel such as coal, gas, or oil. Geothermal fields produce only about one-sixth of the carbon dioxide that a relatively clean natural-gas-fueled power plant produces. Binary plants release essentially no emissions. Unlike solar and wind energy, geothermal energy is always available, 365 days a year. It’s also relatively inexpensive; savings from direct use can be as much as 8But it has some environmental problems. The main concern is the release of hydrogen sulfide, a gas that smells like rotten egg at low concentrations. Another concern is the disposal of some geothermal fluids, which may contain low levels of toxic materials. Although geothermal sites are capable of providing heat for many decades, eventually specific locations may cool down.0 percent over fossil fuels.

with active or geologically young volcanoes. These "hot spots" occur at tectonic plate boundaries or at places where the crust is thin enough to let the heat through. The Pacific Rim, often called the Ring of Fire for its many volcanoes, has many hot spots, including some in Alaska, California, and Oregon. Nevada has hundreds of hot spots, covering much of the northern part of the state.

These regions are also seismically active. Earthquakes and magma movement break up the rock covering, allowing water to circulate. As the water rises to the surface, natural hot springs and geysers occur, such as Old

around the country could provide up to 2,500 megawatts of new capacity [3]. Faithful at Yellowstone National Park. The water in these systems can be more than 200°C (430°F).

Seismically active hotspots are not the only places where geothermal energy can be found. There is a steady supply of milder heat—useful for direct heating purposes—at depths of anywhere from 10 to a few hundred feet below the surface virtually in any location on Earth. Even the ground below your own backyard or local school has enough heat to control the climate in your home or other buildings in the community. In addition, there is a vast amount of heat energy available from dry rock formations very deep below the surface (4–10 km). Using the emerging technology known as Enhanced Geothermal Systems (EGS), we may be able to capture this heat for electricity production on a much larger scale than conventional technologies currently allow. While still primarily in the development phase, the first demonstration EGS projects provided electricity to grids in the United States and Australia in 2013.

If the full economic potential of geothermal resources can be realized, they would represent an enormous source of electricity production capacity. In 2012, the U.S. National Renewable Energy Laboratory (NREL) found that conventional geothermal sources (hydrothermal) in 13 states have a potential capacity of 38,000 MW, which could produce 308 million MWh of electricity annually [4].

State and federal policies are likely to spur developers to tap some of this potential in the next few years. The Geothermal Energy Association estimates that 125 projects now under development

As EGS technologies improve and become competitive, even more of the largely untapped geothermal resource could be developed. The NREL study found that hot dry rock resources could provide another 4 million MW of capacity, which is equivalent to more than all of today’s U.S. electricity needs [4].

Not only do geothermal resources in the United States offer great potential, they can also provide continuous baseload electricity. According to NREL, the capacity factors of geothermal plants—a measure of the ratio of the actual electricity generated over time compared to what would be produced if the plant was running nonstop for that period—are comparable with those of coal and nuclear power [5]. With the combination of both the size of the resource base and its consistency, geothermal can play an indispensable role in a cleaner, more sustainable power system.